Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GX9G |
Model Year Start: 2020 |
Model: GR Corolla |
Prod Date Range: [01/2019 - 09/2022] |
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR (for TMC Made): REMOVAL; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 09/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat position airbag sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock*1
|
Power Door Lock Control System
|
|
NOTICE:
for HV Model:
-
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Audio and Visual System (for HV Model))
for Gasoline Model:
-
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System (for Gasoline Model))
-
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat: Click here
for Power Seat: Click here
2. REMOVE SEAT POSITION AIRBAG SENSOR
(a) Disengage the clamp and disconnect the connector.
|
|
(b) Disengage the seat slide position sensor protector from the pin of the seat position airbag sensor as shown in the illustration.
*a
|
Pin
|
*b
|
Engagement Point
|
|
Disengage in this Direction
|
|
Remove in this Direction
|
(d) Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with bracket.
|
|
(e) Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor from the bracket.
|
|
|