SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Front Door): INSTALLATION; 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM100000001GX8H
Model Year Start: 2020	Model: GR Corolla	Prod Date Range: [01/2019 - 03/2019]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR (for Front Door): INSTALLATION; 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019]

INSTALLATION

PROCEDURE

1. INSTALL SIDE AIRBAG PRESSURE SENSOR

(a) Check that the ignition switch (for Gasoline Model) or power switch (for HV Model) is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

Incorrect

Correct

(d) Insert the side airbag pressure sensor stopper into the door hole, engage the claw and install the side airbag pressure sensor to the front door panel with the nut.

Torque:

9.0 N·m {92 kgf·cm, 80 in·lbf}

NOTICE:

If the side airbag pressure sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the side airbag pressure sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
Make sure that the side airbag pressure sensor stopper is securely inserted into the door hole.
Keep the stud bolt and waterproof rubber seal free of foreign matter.

Stopper

(e) Connect the connector to the side airbag pressure sensor.

White Housing Lock

Connection is completed

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

HINT:

Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).
When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or the part (A) as it may result in an insecure connection.

(f) Check that there is no looseness in the installed parts of the side airbag pressure sensor.

2. INSTALL FRONT DOOR SERVICE HOLE COVER

Click here

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Click here

5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Click here

6. INSTALL FRONT DOOR ASSIST GRIP ASSEMBLY

Click here

7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Click here

8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

for M20A-FKS: Click here

for 2ZR-FAE: Click here

for 2ZR-FXE: Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

9. INSPECT POWER WINDOW OPERATION

for HV Model: Click here

for Gasoline Model: Click here

10. PERFORM DIAGNOSTIC SYSTEM CHECK

for HV Model: Click here

for Gasoline Model: Click here

11. INSPECT SRS WARNING LIGHT

for HV Model: Click here

for Gasoline Model: Click here