| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001GX4E |
| Model Year Start: 2020 | Model: GR Corolla | Prod Date Range: [01/2019 - 03/2019] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION; 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019] | ||
INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Check that the ignition switch (for Gasoline Model) or power switch (for HV Model) is off.
(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
|
*a |
Airbag Connector |
|
*b |
Airbag Connector Locking Button |
|
Push in this Direction |
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(d) Push in the airbag connector locking button to install the airbag connector.
|
(e) Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly. |
|
(f) Engage the 2 claws.
(g) Install the lower No. 1 instrument panel airbag assembly with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Click here
![2020 - 2022 MY Corolla Corolla Hatchback Corolla HV [01/2019 - 09/2022]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (except G16E-GTS): INSTALLATION+](/t3Portal/stylegraphics/info.gif)
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL
Click here
4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
5. INSTALL NO. 1 INSTRUMENT SIDE PANEL
Click here
6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
for Hatchback: Click here
for Sedan: Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
for Hatchback: Click here
for Sedan: Click here
9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FKS: Click here
for 2ZR-FAE: Click here
for 2ZR-FXE: Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
10. PERFORM DIAGNOSTIC SYSTEM CHECK
for HV Model: Click here
for Gasoline Model: Click here
11. INSPECT SRS WARNING LIGHT
for HV Model: Click here
for Gasoline Model: Click here
|
|