K313 (CVT): SHIFT LEVER: INSTALLATION; 2020 - 2023 MY Corolla Corolla Hatchback [01/2019

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM100000001GVWV
Model Year Start: 2020	Model: Corolla Hatchback	Prod Date Range: [01/2019 - 11/2022]
Title: K313 (CVT): SHIFT LEVER: INSTALLATION; 2020 - 2023 MY Corolla Corolla Hatchback [01/2019 - 11/2022]

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Engage the 2 clamps to connect the wire harness to the transmission floor shift assembly.

(b) Connect the shift lock control ECU connector.

(d) Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.

(e) Fully tighten the 4 bolts in the order shown in the illustration.

Torque:

12 N·m {122 kgf·cm, 9 ft·lbf}

2. CONNECT FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE

(a) Push the 2 claws together at the top of the lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to push up the lock piece.

*a	Lock Piece	*b	Bottom View
*c	Push	*d	Push up

(b) Turn the nut of the floor shift transmission control select cable approximately 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

*a	Stopper	*b	Nut
*c	Push in	*d	Turn approximately 180°

HINT:

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

(c) Connect the floor shift transmission control select cable to the transmission floor shift assembly. Check that the spring is positioned at (A) and push in the stopper.

*1	Transmission Floor Shift Assembly	-	-
*a	Stopper	*b	Spring
*c	Nut	*d	Push in

NOTICE:

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.
Make sure that the floor shift transmission control select cable is securely locked.
Do not forcibly pull the floor shift transmission control select cable into the cabin.

(d) Confirm that the shift lever is in N, and then install the end of the floor shift transmission control select cable to the transmission floor shift assembly.

NOTICE:

Securely install the end of the floor shift transmission control select cable to the transmission floor shift assembly.
Install the end of the floor shift transmission control select cable so that its adjustment lock section is on the driver side.

*a	Lock Piece

(e) Push the lock piece into the adjuster case.

*a	Lock Piece
*b	Adjuster Case
*c	Push in

NOTICE:

Check that the park/neutral position switch assembly and shift lever are in N.
Securely push in the lock piece until the 2 claws are engaged.

When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.

*1	Floor Shift Transmission Control Select Cable
*a	Lever Shaft

When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or floor shift transmission control select cable forward or backward.

3. INSTALL CONSOLE BOX ASSEMBLY

Click here

4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Click here

5. INSTALL SHIFT LOCK RELEASE BUTTON COVER

(a) Engage the 2 claws to install the shift lock release button cover to the position indicator housing assembly.

6. INSPECT SHIFT LEVER POSITION

Click here

7. ADJUST SHIFT LEVER POSITION

Click here