| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001GVWK |
| Model Year Start: 2020 | Model: Corolla Hatchback | Prod Date Range: [01/2019 - 09/2022] |
| Title: K313 (CVT): PARK / NEUTRAL POSITION SWITCH: INSTALLATION; 2020 - 2022 MY Corolla Corolla Hatchback [01/2019 - 09/2022] | ||
INSTALLATION
PROCEDURE
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Temporarily install the park/neutral position switch assembly to the continuously variable transaxle assembly with the 2 bolts.
(b) Install the lock nut and lock plate to the park/neutral position switch assembly.
Torque:
6.9 N·m {70 kgf·cm, 61 in·lbf}
|
(c) Temporarily install the control shaft lever. |
|
(d) Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.
(e) Remove the control shaft lever.
|
(f) Align the protrusion with the neutral basic line. |
|
(g) Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
|
(h) Using a screwdriver, bend down the tabs of the lock plate. |
|
(i) Install the control shaft lever to the park/neutral position switch assembly with the nut and washer.
Torque:
12.7 N·m {130 kgf·cm, 9 ft·lbf}
(j) Connect the park/neutral position switch assembly connector.
2. CONNECT FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE
(a) Connect the floor shift transmission control select cable to the No. 1 transmission control cable bracket with a new clip.
(b) Connect the floor shift transmission control select cable to the control shaft lever with the nut.
Torque:
12 N·m {122 kgf·cm, 9 ft·lbf}
NOTICE:
Before connecting the floor shift transmission control select cable, check that the park/neutral position switch assembly and shift lever are in N.
3. INSTALL BATTERY CLAMP SUB-ASSEMBLY
Click here
![2020 MY Corolla [01/2019 - 03/2019]; 2ZR-FAE (ENGINE MECHANICAL): ENGINE ASSEMBLY: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
4. CONNECT ENGINE WIRE
(a) Connect the engine wire to the battery clamp sub-assembly with the bolt and nut.
Torque:
7.0 N·m {71 kgf·cm, 62 in·lbf}
5. INSTALL BATTERY
Click here
6. INSTALL ECM
Click here
7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Click here
8. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Click here
9. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here
10. INSTALL INLET NO. 1 AIR CLEANER
Click here
11. INSTALL RADIATOR SUPPORT OPENING COVER
Click here
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
13. INSPECT SHIFT LEVER POSITION
Click here
14. ADJUST SHIFT LEVER POSITION
Click here
15. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Click here
16. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Click here
|
|