Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GV5O |
Model Year Start: 2020 |
Model: Corolla Hatchback |
Prod Date Range: [01/2019 - 11/2022] |
Title: CLUTCH: CLUTCH SYSTEM (for EC65): BLEEDING; 2020 - 2023 MY Corolla Corolla Hatchback [01/2019 - 11/2022] |
BLEEDING
CAUTION / NOTICE / HINT
NOTICE:
Wash off clutch fluid immediately if it comes in contact with any painted surface.
HINT:
-
If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.
-
In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.
PROCEDURE
1. REMOVE CENTER COWL TOP VENTILATOR LOUVER
Click here
2. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
Click here
3. FILL RESERVOIR WITH BRAKE FLUID
Click here
4. BLEED CLUTCH LINE
(a) Remove the bleeder plug cap.
|
|
*a
|
Bleeder plug cap
|
*b
|
Bleeder plug
|
|
|
(b) Connect a vinyl tube to the bleeder plug.
(c) Depress the clutch pedal 5 times, and then loosen the bleeder plug while the pedal is depressed.*1
(d) When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.*2
(e) Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out.
NOTICE:
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.
(f) Check that all the air has been bled from the clutch line.
(g) Tighten the bleeder plug.
Torque:
8.4 N·m {86 kgf·cm, 74 in·lbf}
(h) Depress the clutch pedal 10 times or more and confirm its operation.
NOTICE:
This must be performed before the engine is started.
(i) Install the bleeder plug cap.
5. INSPECT FOR BRAKE FLUID LEAK
6. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
Click here
7. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
Click here
8. INSTALL CENTER COWL TOP VENTILATOR LOUVER
Click here
|