| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001GTQZ |
| Model Year Start: 2020 | Model: GR Corolla | Prod Date Range: [01/2019 - 03/2019] |
| Title: LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY (for Sedan): REMOVAL; 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER
(a) Using a moulding remover, disengage the 3 claws as shown in the illustration.
|
Insert Moulding Remover Here |
|
Remove in this Direction |
(b) Disengage the 2 claws and guide to remove the rear combination light cover as shown in the illustration.
|
|
Remove in this Direction |
2. REMOVE REAR COMBINATION LIGHT ASSEMBLY
(a) Apply protective tape around the rear combination light assembly as shown in the illustration.
|
Protective Tape |
|
(b) Remove the 2 screws. |
|
(c) Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.
|
*a |
Pin |
|
*b |
Guide |
|
|
Remove in this Direction |
NOTICE:
To prevent the rear combination light assembly from falling when disengaging the pin and guides, make sure to hold the rear combination light assembly.
|
(d) Disengage the clamp. |
|
(e) for Bulb Type Rear Side Marker Light:
(1) Turn the rear combination light cord with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
|
|
Disconnect in this Direction |
(2) Turn the rear combination light cord with the rear side marker light bulb as shown in the illustration to disconnect them as a unit.
(3) Disconnect the connector to remove the rear combination light assembly.
(f) for LED Type Rear Side Marker Light:
(1) Turn the rear combination light cord with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
|
|
Disconnect in this Direction |
(2) Disconnect the 3 connectors to remove the rear combination light assembly.
3. REMOVE REAR COMBINATION LIGHT CORD
|
(a) Remove the 3 clips. |
|
(b) Turn back the luggage compartment trim cover assembly as shown in the illustration.
|
|
Turn back in this Direction |
(c) Disconnect the connector.
|
*A |
for LH Side |
*B |
for RH Side |
|
(d) Disengage the grommet to remove the rear combination light cord. |
|
|
|