INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

Torque:

6.0 N·m {61 kgf·cm, 53 in·lbf}

(b) Engage the guide and connect the transmission control cable assembly to the vehicle body.

(c) Install the nut.

Torque:

6.0 N·m {61 kgf·cm, 53 in·lbf}

(d) Install the transmission control cable assembly to the control cable bracket assembly with 2 new clips (B). NOTICE: Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket assembly before installing the clips.

*a Paint Mark

(e) Connect the transmission control cable assembly to the manual transaxle assembly with the 2 clips (A).

(f) Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.

*a Nut *b Stopper *c Turn *d Push

(g) Install the transmission control shift cable to the shift lever retainer, check that the position of the spring is the same as (A) shown in the illustration, and press in the stopper. NOTICE: Do not forcibly pull the transmission control cable assembly into the cabin. HINT: If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

*1 Shift Lever Retainer (Floor Shift Lever Assembly) *a Nut *b Stopper *c Spring *d Push

(h) Install the transmission control select cable to the shift lever retainer, check that the position of the spring is the same as (A) shown in the illustration, and press in the stopper.

NOTICE:

Do not forcibly pull the transmission control cable assembly into the cabin.

HINT:

If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

(i) Connect the transmission control shift cable to the floor shift lever assembly.

(j) Connect the transmission control select cable to the floor shift lever assembly with the clip.

2. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

Click here

3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

(a) Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

Torque:

5.0 N·m {51 kgf·cm, 44 in·lbf}

4. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Click here

5. INSTALL FRONT FLOOR CENTER BRACE

Click here

6. INSTALL BATTERY CLAMP SUB-ASSEMBLY

Click here

7. CONNECT ENGINE WIRE

(a) Connect the engine wire to the battery clamp sub-assembly with the bolt and nut.

Torque:

7.0 N·m {71 kgf·cm, 62 in·lbf}

8. INSTALL ECM

Click here

9. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Click here

10. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Click here

11. INSTALL INLET NO. 1 AIR CLEANER

Click here

12. INSTALL RADIATOR SUPPORT OPENING COVER

Click here

13. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Click here

14. INSTALL CONSOLE BOX ASSEMBLY

Click here

15. INSTALL BATTERY

Click here

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

17. INSPECT FOR EXHAUST GAS LEAK

Click here