Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GLOW |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 - 09/2022] |
Title: MAINTENANCE: 2ZR-FXE AUXILIARY BATTERY: REMOVAL; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Auxiliary battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane Control System (for HV Model)
|
|
Pre-collision System (for HV Model)
|
NOTICE:
-
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Audio and Visual System (for HV Model))
-
When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
|
|
2. REMOVE AUXILIARY BATTERY
(a) Disengage the 2 claws and open the fusible link cover in the order shown in the illustration.
*a
|
Top View of Claws
|
-
|
-
|
|
Push fusible link cover here
|
|
Push
|
|
Open
|
-
|
-
|
(b) Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.
|
|
(c) Remove the bolt.
|
Remove in this Direction
|
(d) Remove the No. 2 battery clamp as shown in the illustration.
(e) Remove the auxiliary battery.
|