2ZR-FAE (BATTERY / CHARGING): GENERATOR: REMOVAL; 2020 MY Corolla [01/2019

Last Modified: 07-31-2024	6.11:8.1.0	Doc ID: RM100000001GLNT
Model Year Start: 2020	Model: Corolla	Prod Date Range: [01/2019 - 03/2019]
Title: 2ZR-FAE (BATTERY / CHARGING): GENERATOR: REMOVAL; 2020 MY Corolla [01/2019 - 03/2019]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during generator assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not performed
Battery terminal is disconnected/reconnected	Perform steering sensor zero point calibration	Lane Control System (for Gasoline Model)
		Pre-collision System (for Gasoline Model)
		Lighting System (w/ AFS)(EXT)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System (for Gasoline Model))
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click here

2. REMOVE V-RIBBED BELT

Click here

3. REMOVE GENERATOR ASSEMBLY

(a) Remove the terminal cap.

(b) Remove the nut and disconnect the wire harness from terminal B.

(d) Disengage the wire harness clamp.

(e) Remove the 2 bolts and generator assembly.

(f) Remove the bolt and wire harness clamp bracket.