Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GLN5 |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 - 04/2020] |
Title: 2ZR-FXE (LUBRICATION): OIL PUMP: REMOVAL; 2020 MY Corolla Corolla HV [01/2019 - 04/2020] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil pump assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Replacement of inverter with converter assembly
|
Resolver learning
|
-
DTCs are stored
-
Slight vibration at a vehicle speed of 5 km/h (3 mph) or less
-
Shock or vibration during acceleration
|
|
Replacement of hybrid vehicle transaxle assembly
|
-
Resolver learning
-
Initialize resolver
|
Replacement of ECM
|
Vehicle Identification Number (VIN) registration
|
MIL comes on
|
|
-
Replacement of throttle body assembly
-
Replacement of cylinder head sub-assembly
-
Replacement of camshaft (for intake or exhaust camshaft)
-
Replacement of camshaft timing gear assembly
-
Replacement of fuel injector assembly
-
Replacement of ignition coil assembly
-
Replacement of EGR valve assembly
-
Gas leak from exhaust system is repaired
|
Inspection After Repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
Front wheel alignment adjustment
|
-
Clear zero point calibration data
-
Perform yaw rate and acceleration sensor zero point calibration
|
-
DTCs are stored
-
ABS warning light illuminates
-
Brake warning light / yellow (minor malfunction) illuminates
-
Slip indicator light illuminates
-
VSC disabled or malfunctions
|
|
NOTICE:
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Audio and Visual System (for HV Model))
PROCEDURE
1. REMOVE CHAIN SUB-ASSEMBLY
Click here
2. REMOVE CRANKSHAFT TIMING SPROCKET
Click here
3. REMOVE NO. 2 CHAIN SUB-ASSEMBLY
Click here
4. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
Click here
5. REMOVE OIL PUMP ASSEMBLY
(a) Remove the 3 bolts and oil pump assembly from the stiffening crankcase assembly.
|
|
|