Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GL4Q |
Model Year Start: 2020 |
Model: GR Corolla |
Prod Date Range: [01/2019 - 04/2020] |
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (for Gasoline Model with Dual Knob Type): Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver; 2020 MY Corolla Corolla Hatchback GR Corolla [01/2019 - 04/2020] |
Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver
|
DESCRIPTION
The DCM (telematics transceiver) sends a mute signal to the stereo component amplifier assembly.
The stereo component amplifier assembly controls the volume according to the mute signal from the DCM (telematics transceiver).
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly may not operate normally.
-
Before replacing the DCM (telematics transceiver), refer to Registration.
Click here
PROCEDURE
1.
|
INSPECT DCM (TELEMATICS TRANSCEIVER)
|
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
I72-17 (MUTE) - Body ground
|
Ignition switch ACC
Audio system playing
→ Emergency call mode
|
2.0 V or higher
→ Below 1 V
|
|
|
*a
|
Component with harness connected
(DCM (Telematics Transceiver))
|
|
|
NG
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - DCM (TELEMATICS TRANSCEIVER))
|
(a) Disconnect the I68 stereo component amplifier assembly connector.
(b) Disconnect the I72 DCM (telematics transceiver) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I68-24 (TMUT) - I72-17 (MUTE)
|
Always
|
Below 1 Ω
|
I68-24 (TMUT) or I72-17 (MUTE) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
3.
|
INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
|
(a) Disconnect the I72 DCM (telematics transceiver) connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
I72-17 (MUTE) - Body ground
|
Ignition switch ACC
|
2.0 V or higher
|
|
|
*a
|
Front view of wire harness connector
(to DCM (Telematics Transceiver))
|
|
|
|