FRONT SUSPENSION: FRONT LOWER SUSPENSION ARM (for ZR Series Engine RH Side): INSTALLATION; 2020 - 2022 MY Corolla Corolla HV [01/2019

Last Modified: 05-13-2024	6.11:8.1.0	Doc ID: RM100000001GJDK
Model Year Start: 2020	Model: Corolla	Prod Date Range: [01/2019 - 09/2022]
Title: FRONT SUSPENSION: FRONT LOWER SUSPENSION ARM (for ZR Series Engine RH Side): INSTALLATION; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022]

INSTALLATION

PROCEDURE

1. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

(a) Temporarily install the front lower No. 1 suspension arm sub-assembly RH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Click here

3. INSTALL FRONT WHEEL

Click here

4. STABILIZE SUSPENSION

Click here

5. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

(a) Using SST, fully tighten the bolt (A).

SST: 09961-01270

*a	Torque Wrench Fulcrum Length
	Turn

Torque:

Specified tightening torque :

240 N·m {2447 kgf·cm, 177 ft·lbf}

HINT:

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click here
When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 600 mm (1.97 ft.)):
180 N*m (1835 kgf*cm, 133 ft.*lbf)

(b) Fully tighten the bolt (B).

Torque:

125 N·m {1275 kgf·cm, 92 ft·lbf}

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Click here