| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001GHYN |
| Model Year Start: 2020 | Model: Corolla Hatchback | Prod Date Range: [01/2019 - 11/2022] |
| Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB (for Double Wishbone Type Suspension 2WD without Electric Parking Brake): ON-VEHICLE INSPECTION; 2020 - 2023 MY Corolla Corolla Hatchback Corolla HV [01/2019 - 11/2022] | ||
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
![2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019]; MAINTENANCE: TIRE AND WHEEL: REMOVAL+](/t3Portal/stylegraphics/info.gif)
2. LOOSEN NO. 1 WIRE ADJUSTING NUT
Click here
3. REMOVE PARKING BRAKE LEVER PROTECTOR
Click here
4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Click here
5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
6. REMOVE REAR DISC
Click here
7. INSPECT REAR AXLE HUB BEARING LOOSENESS
|
(a) Using a dial indicator with magnetic base, check for looseness near the center of the rear axle hub. Maximum Looseness: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
8. INSPECT REAR AXLE HUB RUNOUT
|
(a) Using a dial indicator with magnetic base, check for runout on the surface of the rear axle hub outside the rear axle hub bolts. Maximum Runout: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the runout exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
9. INSTALL REAR DISC
Click here
10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here
11. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Click here
12. INSTALL PARKING BRAKE LEVER PROTECTOR
Click here
13. ADJUST PARKING BRAKE
Click here
14. INSTALL REAR WHEEL
Click here
|
|