CRUISE CONTROL: FRONT CAMERA SYSTEM (for HV Model): U030057; Internal Control Module Software Incompatibility Invalid / Incompatible Software Component; 2020 MY Corolla Corolla HV [01/2019

Last Modified: 07-31-2024	6.11:8.1.0	Doc ID: RM100000001GGB8
Model Year Start: 2020	Model: Corolla	Prod Date Range: [01/2019 - 04/2020]
Title: CRUISE CONTROL: FRONT CAMERA SYSTEM (for HV Model): U030057; Internal Control Module Software Incompatibility Invalid / Incompatible Software Component; 2020 MY Corolla Corolla HV [01/2019 - 04/2020]

DTC

U030057

Internal Control Module Software Incompatibility Invalid / Incompatible Software Component

DESCRIPTION

Forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication.

DTC U030057 is stored when the vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
U030057	Internal Control Module Software Incompatibility Invalid / Incompatible Software Component	The vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match.	Hybrid control system Forward recognition camera Hybrid vehicle control ECU

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU, refer to Registration.
Click here
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
HINT:

Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

One Time Recognition: Click here

Sequential Recognition: Click here

PROCEDURE

1.	CHECK FOR DTCs

(a) Check for DTCs of hybrid control system.

Powertrain > Hybrid Control > Trouble Codes

Result	Proceed to
DTCs are not output	A
DTCs are output	B

GO TO HYBRID CONTROL SYSTEM

2.	CHECK FOR DTCs (HEALTH CHECK)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(d) Enter the following menus: System Select / Health Check.

(e) Check for DTCs.

(f) Turn the power switch off.

OK:

DTCs indicating a vehicle information mismatch with that of the hybrid vehicle control ECU are not output by any ECU other than the forward recognition camera.

REPLACE HYBRID VEHICLE CONTROL ECU

3.	READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(d) Enter the following menus: Chassis / Front Recognition Camera / Data List.

(e) Read the Data List according to the display on the Techstream.

Chassis > Front Recognition Camera > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

HV Equipped Information

Vehicle information (conventional/hybrid) stored in forward recognition camera

Non-HV / HV

Non-HV: Conventional vehicle

HV: Hybrid vehicle

Chassis > Front Recognition Camera > Data List

Tester Display
HV Equipped Information

HINT:

If the vehicle information stored in the forward recognition camera is different from the actual vehicle specifications, the vehicle information stored in the forward recognition camera may be incorrect. Replace the forward recognition camera.
If the vehicle information stored in the forward recognition camera matches the actual vehicle specifications, the installed hybrid vehicle control ECU is incompatible. Replace the hybrid vehicle control ECU.

Result	Proceed to
Vehicle information stored in forward recognition camera and actual vehicle specifications do not match	A
Vehicle information stored in forward recognition camera and actual vehicle specifications match	B

REPLACE FORWARD RECOGNITION CAMERA

REPLACE HYBRID VEHICLE CONTROL ECU