- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001GFPP |
| Model Year Start: 2020 | Model: Corolla | Prod Date Range: [01/2019 - ] |
| Title: 2ZR-FXE (EMISSION CONTROL): PURGE VALVE: REMOVAL; 2020 - 2025 MY Corolla Corolla HV [01/2019 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during purge valve (purge VSV) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Gas leaks from exhaust system is repaired |
Inspection after repair |
|
|
NOTICE:
When removing the fuel vapor feed hose, hold the purge valve body securely in place by hand.
PROCEDURE
1. DRAIN ENGINE COOLANT (for Engine)
Click here
![2020 MY Corolla Corolla HV [01/2019 - 04/2020]; MAINTENANCE: 2ZR-FXE COOLANT (for Engine Coolant): REPLACEMENT+](/t3Portal/stylegraphics/info.gif)
2. REMOVE EGR PIPE ASSEMBLY
Click here
3. DISCONNECT NO. 8 WATER BY-PASS HOSE
|
(a) Slide the clip and disconnect the No. 8 water by-pass hose from the No. 3 water by-pass pipe. |
|
4. DISCONNECT NO. 9 WATER BY-PASS HOSE
|
(a) Slide the clip and disconnect the No. 9 water by-pass hose from the No. 3 water by-pass pipe. |
|
5. REMOVE PURGE VALVE (PURGE VSV)
|
(a) Disconnect the purge valve (purge VSV) connector. |
|
(b) Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).
(c) Disconnect the No. 2 fuel vapor feed hose from the purge valve (purge VSV).
|
(d) Remove the bolt and purge valve (purge VSV) with No. 3 water by-pass pipe from the camshaft housing sub-assembly. |
|
|
(e) Remove the screw and purge valve (purge VSV) from the No. 3 water by-pass pipe. |
|
|
|