Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001GFIH |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 - 11/2022] |
Title: DRIVE SHAFT / PROPELLER SHAFT: FRONT DRIVE SHAFT ASSEMBLY (for 2ZR-FAE): REMOVAL; 2020 - 2023 MY Corolla [01/2019 - 11/2022] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Front wheel alignment adjustment
|
-
Perform "Reset Memory"
-
Perform acceleration sensor zero point calibration and store system information memorization
|
-
VSC is disabled or malfunctions
-
DTCs are output
-
Slip indicator light illuminates
-
ABS warning light illuminates
|
w/ Electric Parking Brake System:
w/o Electric Parking Brake System:
|
CVT fluid
|
ATF thermal degradation estimate reset
|
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
|
|
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEELS
Click here
2. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
3. REMOVE REAR ENGINE UNDER COVER LH
Click here
4. REMOVE REAR ENGINE UNDER COVER RH
Click here
5. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID (for CVT)
Click here
6. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle)
Click here
7. REMOVE FRONT AXLE SHAFT NUT
(a) Using SST and a hammer, release the staked part of the front axle shaft nut.
SST: 09930-00010
NOTICE:
Loosen the staked part of the front axle shaft nut completely, otherwise the threads of the drive shaft may be damaged.
|
|
(b) While applying the brakes, remove the front axle shaft nut.
8. SEPARATE FRONT SPEED SENSOR
Click here
9. SEPARATE TIE ROD END SUB-ASSEMBLY
Click here
10. SEPARATE FRONT STABILIZER LINK ASSEMBLY
Click here
11. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Click here
12. SEPARATE FRONT DRIVE SHAFT ASSEMBLY
Click here
13. REMOVE FRONT DRIVE SHAFT ASSEMBLY
(a) Using SST, remove the front drive shaft assembly.
SST: 09520-01011
SST: 09520-20010
09521-02010
09521-02040
09521-02060
NOTICE:
-
Do not damage the front drive shaft oil seal LH.
-
Do not damage the front axle inboard joint boot.
-
Do not drop the front drive shaft assembly.
|
|
14. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
(a) Using a screwdriver, remove the front drive shaft hole snap ring.
|
|
|