| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001G7JE |
| Model Year Start: 2020 | Model: GR Corolla | Prod Date Range: [01/2019 - 09/2022] |
| Title: DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION; 2020 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 09/2022] | ||
INSTALLATION
PROCEDURE
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet.
(c) Engage each clamp to install the hood lock control cable assembly.
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
![2020 - 2022 MY Corolla Corolla Hatchback Corolla HV [01/2019 - 09/2022]; INTERIOR PANELS / TRIM: FRONT CONSOLE BOX (except G16E-GTS): INSTALLATION+](/t3Portal/stylegraphics/info.gif)
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
5. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
6. INSTALL HOOD LOCK ASSEMBLY
(a) Apply MP grease to the sliding areas of the hood lock assembly.
(b) Connect the hood lock control cable assembly to the hood lock assembly.
(c) for Hatchback:
(1) Install the hood lock assembly with the 2 bolts and hood lock bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
HINT:
The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.
(d) for Sedan:
(1) Install the hood lock assembly with the 3 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(e) w/ Engine Hood Courtesy Switch:
(1) Engage the clamp.
(2) Connect the connector.
7. INSTALL HEADLIGHT ASSEMBLY LH
Click here
8. INSTALL FRONT FENDER LINER LH
Click here
9. INSTALL FRONT WHEEL LH
Click here
10. INSTALL INLET NO. 1 AIR CLEANER (w/ Engine Hood Courtesy Switch)
for M20A-FKS:
Click here
for 2ZR-FAE:
Click here
11. ADJUST HOOD SUB-ASSEMBLY
Click here
|
|