Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001G707 |
Model Year Start: 2020 |
Model: Corolla |
Prod Date Range: [01/2019 - 09/2022] |
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM (for HV Model): B150718; Turn Signal Light Circuit Current Below Threshold; 2020 - 2022 MY Corolla Corolla HV [01/2019 - 09/2022] |
DTC
|
B150718
|
Turn Signal Light Circuit Current Below Threshold
|
DESCRIPTION
This DTC is stored when the combination meter assembly detects an open in a front turn signal light circuit or rear turn signal light circuit.
HINT:
-
If there is an open in a front turn signal light circuit or rear turn signal light circuit, the turn signal lights on the side with the open circuit will blink faster than usual.
-
If there is an open in a side turn signal light circuit, DTC B150718 will not be stored.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B150718
|
Turn Signal Light Circuit Current Below Threshold
|
Diagnosis Condition:
-
Auxiliary battery voltage is 10 V or more
Malfunction Status:
-
Open in front turn signal light circuit
-
Open in rear turn signal light circuit
|
-
Headlight unit assembly
-
Rear combination light cord
-
Rear turn signal light bulb
-
Harness or connector
-
Combination meter assembly
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
-
Inspect the turn signal light bulbs before performing the following procedure.
PROCEDURE
(a) Check the problem symptoms.
Result
|
Proceed to
|
LH side front turn signal light does not blink
|
A
|
LH side rear turn signal light does not blink
|
B
|
RH side front turn signal light does not blink
|
C
|
RH side rear turn signal light does not blink
|
D
|
A
|
|
|
2.
|
CHECK LH SIDE FRONT TURN SIGNAL LIGHT (HEADLIGHT UNIT ASSEMBLY LH)
|
(a) Interchange the headlight unit assembly LH with RH and connect the connectors.
Click here
(b) Operate the turn signal switch and check that the LH side front turn signal light operates normally.
HINT:
If the LH side front turn signal light operates normally, the headlight unit assembly LH is malfunctioning.
Result
|
Proceed to
|
LH side front turn signal light operates normally
|
A
|
Problem symptoms do not change
(LH side front turn signal light does not blink)
|
B
|
B
|
|
|
3.
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY LH - COMBINATION METER ASSEMBLY AND BODY GROUND)
|
(a) Disconnect the A83 headlight assembly LH connector.
(b) Disconnect the I5 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A83-2 (B) - I5-1 (LL)
|
Always
|
Below 1 Ω
|
A83-3 (E) - Body ground
|
Always
|
Below 1 Ω
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
4.
|
CHECK LH SIDE REAR TURN SIGNAL LIGHT (REAR COMBINATION LIGHT CORD LH)
|
(a) Interchange the rear combination light cord LH with RH and connect the connectors.
Click here
(b) Operate the turn signal switch and check that the LH side rear turn signal light operates normally.
HINT:
If the LH side rear turn signal lights operates normally, the rear combination light cord LH is malfunctioning.
Result
|
Proceed to
|
LH side rear turn signal lights operates normally
|
A
|
Problem symptoms do not change
(LH side rear turn signal light does not blink)
|
B
|
B
|
|
|
5.
|
CHECK HARNESS AND CONNECTOR (REAR COMBINATION LIGHT ASSEMBLY LH - COMBINATION METER ASSEMBLY AND BODY GROUND)
|
(a) Disconnect the O104 rear combination light assembly LH connector.
(b) Disconnect the I5 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
O104-3 (B) - I5-5 (TRNL)
|
Always
|
Below 1 Ω
|
O104-4 (E) - Body ground
|
Always
|
Below 1 Ω
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
6.
|
CHECK RH SIDE FRONT TURN SIGNAL LIGHT (HEADLIGHT UNIT ASSEMBLY RH)
|
(a) Interchange the headlight unit assembly RH with LH and connect the connectors.
Click here
(b) Operate the turn signal switch and check that the RH side front turn signal light operates normally.
HINT:
If the RH side front turn signal light operates normally, the headlight unit assembly RH is malfunctioning.
Result
|
Proceed to
|
RH side front turn signal light operates normally
|
A
|
Problem symptoms do not change
(RH side front turn signal light does not blink)
|
B
|
B
|
|
|
7.
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY RH - COMBINATION METER ASSEMBLY AND BODY GROUND)
|
(a) Disconnect the A82 headlight assembly RH connector.
(b) Disconnect the I5 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A82-2 (B) - I5-2 (LR)
|
Always
|
Below 1 Ω
|
A82-3 (E) - Body ground
|
Always
|
Below 1 Ω
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
8.
|
CHECK RH SIDE REAR TURN SIGNAL LIGHT (REAR COMBINATION LIGHT CORD RH)
|
(a) Interchange the rear combination light cord RH with LH and connect the connectors.
Click here
(b) Operate the turn signal switch and check that the RH side rear turn signal light operates normally.
HINT:
If the RH side rear turn signal lights operates normally, the rear combination light cord RH is malfunctioning.
Result
|
Proceed to
|
RH side rear turn signal lights operates normally
|
A
|
Problem symptoms do not change
(RH side rear turn signal light does not blink)
|
B
|
B
|
|
|
9.
|
CHECK HARNESS AND CONNECTOR (REAR COMBINATION LIGHT ASSEMBLY RH - COMBINATION METER ASSEMBLY AND BODY GROUND)
|
(a) Disconnect the O103 rear combination light assembly RH connector.
(b) Disconnect the I5 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
O103-3 (B) - I5-6 (TRNR)
|
Always
|
Below 1 Ω
|
O103-4 (E) - Body ground
|
Always
|
Below 1 Ω
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|