Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001D2L6 |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 09/2022] |
Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model with Electric Parking Brake System): P057113; Brake Switch "A" Circuit Open; 2019 - 2022 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2022] |
DTC
|
P057113
|
Brake Switch "A" Circuit Open
|
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied.
The skid control ECU (brake actuator assembly) has a detection circuit that it uses to detect an open in the stop light input line.
If the skid control ECU (brake actuator assembly) detects an open in this circuit, it will store this DTC.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
P057113
|
Brake Switch "A" Circuit Open
|
An open in the stop light switch assembly input line continues for 3 seconds or more.
|
-
Stop light switch assembly
-
Wire harness or connector
-
Skid control ECU (brake actuator assembly)
|
WIRING DIAGRAM
Refer to DTC P057111.
Click here
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Click here
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY OUTPUT CIRCUIT)
|
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK:
The connector is securely connected.
|
|
*a
|
Component with harness connected
(Stop Light Switch Assembly)
|
|
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
A53-3 (L) - Body ground
|
Brake pedal depressed
|
11 to 14 V
|
A53-3 (L) - Body ground
|
Brake pedal released
|
Below 1.5 V
|
OK
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY INPUT CIRCUIT)
|
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK:
The connector is securely connected.
|
|
*a
|
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))
|
|
|
(b) Disconnect the A51 skid control ECU (brake actuator assembly) connector.
(c) Check both the connector case and the terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
A51-41 (STP) - Body ground
|
Brake pedal depressed
|
11 to 14 V
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|