| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001D1O5 |
| Model Year Start: 2019 | Model: GR Corolla | Prod Date Range: [06/2018 - 09/2022] |
| Title: DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM (for Hatchback, Gasoline Model): Only Back Door cannot be Opened; 2019 - 2022 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2022] | ||
|
Only Back Door cannot be Opened |
DESCRIPTION
The main body ECU (multiplex network body ECU) receives signals from the back door opener switch sub-assembly. When a signal received is the main body ECU (multiplex network body ECU) activates the back door lock motor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
-
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
![2019 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 01/2019]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, Gasoline Model): REGISTRATION](/t3Portal/stylegraphics/info.gif)
-
The power door lock control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power door lock control system after confirming that the communication systems are functioning properly.
Click here
-
Before performing this troubleshooting procedure , perform troubleshooting for the smart key system (for Entry Function) (Back Door Entry Unlock Function does not Operate) first.
Click here
PROCEDURE
|
1. |
INSPECT BACK DOOR LOCK ASSEMBLY |
(a) Remove the back door lock assembly.
Click here
(b) Inspect the back door lock assembly.
Click here
| NG |
|
|
|
2. |
CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND) |
(a) Disconnect the 4A instrument panel junction block assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V3-1 (ACT+) - 4A-20 |
Always |
Below 1 Ω |
|
V3-2 (ACT-) - Body ground |
Always |
Below 1 Ω |
|
V3-1 (ACT+) or 4A-20 - Other terminals and body ground |
Always |
10 kΩ or higher |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3. |
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
(a) Replace the instrument panel junction block assembly.
Click here
|
|
4. |
CHECK BACK DOOR OPEN OPERATION |
(a) Check that the back door can be opened.
OK:
The back door can be opened.
| OK |
|
END (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WAS DEFECTIVE) |
| NG |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
|
|