| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001D1NC |
| Model Year Start: 2019 | Model: GR Corolla | Prod Date Range: [06/2018 - 01/2019] |
| Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SENSOR: REMOVAL; 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|---|---|---|---|
|
Blind spot monitor sensor |
Blind spot monitor beam axis adjustment |
Blind Spot Monitor System |
|
PROCEDURE
1. REMOVE REAR BUMPER ASSEMBLY
Click here
![2019 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - ]; EXTERIOR PANELS / TRIM: REAR BUMPER (for Hatchback except GR): REMOVAL](/t3Portal/stylegraphics/info.gif)
2. REMOVE BLIND SPOT MONITOR SENSOR LH
|
(a) Disconnect the connector. |
|
(b) Remove the 3 nuts and blind spot monitor sensor LH.
NOTICE:
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.
3. REMOVE BLIND SPOT MONITOR SENSOR RH
|
(a) Disconnect the connector. |
|
(b) Remove the 3 nuts and blind spot monitor sensor RH.
NOTICE:
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.
|
|