| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001D0VQ |
| Model Year Start: 2019 | Model: GR Corolla | Prod Date Range: [06/2018 - 09/2022] |
| Title: FRONT SUSPENSION: FRONT STABILIZER BAR: INSTALLATION; 2019 - 2022 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 09/2022] | ||
INSTALLATION
PROCEDURE
1. INSTALL FRONT STABILIZER BAR BUSHING LH
(a) Install the front stabilizer bar bushing LH to the front stabilizer bar as shown in the illustration.
|
*a |
Cutout |
|
*b |
Stopper Ring |
|
Front of the Vehicle |
|
Outside of the Vehicle |
NOTICE:
- Install the front stabilizer bar bushing LH so that the cutout is facing the rear of the vehicle.
- Install the front stabilizer bar bushing LH onto the front stabilizer bar so that the stopper ring of the front stabilizer bar faces the outside of the vehicle.
2. INSTALL FRONT STABILIZER BAR BUSHING RH
HINT:
Perform the same procedure as for the LH side.
3. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar with the 2 front stabilizer bar bushings to the front suspension crossmember sub-assembly.
NOTICE:
Make sure that the identification mark is positioned on the right side of the vehicle.
|
*a |
Identification Mark |
- |
- |
|
|
Front of the Vehicle |
- |
- |
4. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
(a) Install the front No. 1 stabilizer bracket LH to the front suspension crossmember sub-assembly with the 2 bolts.
Torque:
93 N·m {948 kgf·cm, 69 ft·lbf}
NOTICE:
- Make sure to install the front No. 1 stabilizer bracket LH with its arrow facing the front of the vehicle.
- Temporarily tighten the bolt (B) and then fully tighten the 2 bolts in the order of (A) and (B).
|
*a |
Arrow |
|
|
Front of the Vehicle |
5. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT:
Perform the same procedure as for the LH side.
6. INSTALL STEERING LINK ASSEMBLY
Click here
![2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019]; STEERING GEAR / LINKAGE: STEERING GEAR: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link assembly LH to the front shock absorber assembly with the nut.
Torque:
74 N·m {755 kgf·cm, 55 ft·lbf}
HINT:
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:
Perform the same procedure as for the LH side.
9. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Click here
|
|