Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001D0M2 |
Model Year Start: 2019 |
Model: Corolla Hatchback |
Prod Date Range: [06/2018 - 01/2019] |
Title: K120 / K121 (CVT): K120 TCM: REMOVAL; 2019 MY Corolla Corolla Hatchback [06/2018 - 01/2019] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during TCM removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure
|
Necessary Procedure
|
Effect/Inoperative when not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock
|
Power Door Lock Control System
|
|
Replacement of TCM
(If transaxle compensation code read from TCM)
|
-
Transfer transaxle compensation code
-
Perform reset memory*
-
Deceleration sensor zero point calibration
-
CVT oil pressure calibration
-
Perform road test to allow TCM to learn
|
-
Large shift shock
-
Deterioration of fuel efficiency
|
for Initialization
for Registration
|
Replacement of TCM
(If transaxle compensation code not read from TCM)
|
-
Reset transaxle compensation code
-
Perform reset memory*
-
Deceleration sensor zero point calibration
-
CVT oil pressure calibration
-
Perform road test to allow TCM to learn
|
NOTICE:
-
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)
-
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here
4. REMOVE REAR ENGINE UNDER COVER LH
Click here
5. REMOVE TCM
(a) Remove the bolt to disconnect the engine wire from the No. 2 transmission control ECU bracket.
|
|
(b) Disengage the claw, rotate the lever and disconnect the TCM connector.
|
Remove in this Direction
|
(c) Remove the 2 bolts and TCM from the continuously variable transaxle assembly.
|
|
6. REMOVE NO. 1 TRANSMISSION CONTROL ECU BRACKET
(a) Remove the 2 screws and No. 1 transmission control ECU bracket from the TCM.
|
|
7. REMOVE NO. 2 TRANSMISSION CONTROL ECU BRACKET
(a) Remove the 2 screws and No. 2 transmission control ECU bracket from the TCM.
|
|
|