| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001D0LV |
| Model Year Start: 2019 | Model: Corolla Hatchback | Prod Date Range: [06/2018 - ] |
| Title: K120 / K121 (CVT): K120 PARK / NEUTRAL POSITION SWITCH: ADJUSTMENT; 2019 - 2025 MY Corolla Corolla Hatchback [06/2018 - ] | ||
ADJUSTMENT
CAUTION / NOTICE / HINT
NOTICE:
Before adjusting the park/neutral position switch assembly, check that the shift lever is in N.
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
- Make sure to apply the parking brake and chock a wheel before performing this procedure.
- If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2. DISCONNECT FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE
Click here
![2019 MY Corolla Corolla Hatchback [06/2018 - 01/2019]; K120 / K121 (CVT): K120 PARK / NEUTRAL POSITION SWITCH: REMOVAL](/t3Portal/stylegraphics/info.gif)
3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
|
(a) Disconnect the park/neutral position switch assembly connector. |
|
(b) Using a piece of wood or equivalent to secure the transmission control shaft lever to prevent it from rotating, remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.
NOTICE:
If the transmission control shaft lever is not secured when loosening the nut, the manual valve link lever sub-assembly may separate from the manual valve.
|
*1 |
Transmission Control Shaft Lever |
|
*a |
Manual Valve Link Lever Sub-assembly |
|
*b |
Manual Valve |
|
*a |
Piece of Wood or Equivalent |
|
(c) Loosen the 2 bolts of the park/neutral position switch assembly. |
|
|
(d) Align the protrusions of the park/neutral position switch assembly as shown in the illustration. |
|
(e) Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(f) Install the transmission control shaft lever to the manual valve lever shaft with the washer and nut.
Torque:
12.7 N·m {130 kgf·cm, 9 ft·lbf}
(g) Connect the park/neutral position switch assembly connector.
4. CONNECT FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE
Click here
5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
Click here
|
|