- Replacement of EGR valve assembly
- Gas leaks from exhaust system is repaired
| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001D0H9 |
| Model Year Start: 2019 | Model: Corolla Hatchback | Prod Date Range: [06/2018 - 09/2019] |
| Title: M20A-FKS (EMISSION CONTROL): EGR VALVE: REMOVAL; 2019 - 2020 MY Corolla Corolla Hatchback [06/2018 - 09/2019] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedures |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
|
Inspection after repair |
|
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![2019 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
2. REMOVE EGR COOLER ASSEMBLY
Click here
3. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
|
(a) Disconnect the EGR valve assembly connector. |
|
|
(b) Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly. |
|
|
(c) Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly. |
|
|
(d) Remove the EGR inlet gasket from the intake manifold. |
|
4. REMOVE EGR VALVE ASSEMBLY
|
(a) Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly. |
|
(b) Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.
|
(c) Using the 8 mm socket wrench, remove the 2 bolts and EGR valve assembly. |
|
|
|