INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

*a	Airbag Connector
*b	Airbag Connector Locking Button
	Push in this Direction

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

(d) Push in the airbag connector locking button to install the airbag connector.

(e) Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.

(f) Engage the 2 claws.

(g) Install the lower No. 1 instrument panel airbag assembly with the 2 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Click here

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL

Click here

4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

5. INSTALL NO. 1 INSTRUMENT SIDE PANEL

Click here

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

8. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

10. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

11. INSPECT SRS WARNING LIGHT

Click here