Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001D0AU |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 03/2019] |
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Steering Pad Switch Circuit; 2019 - 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 03/2019] |
Steering Pad Switch Circuit
|
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.
Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself will not function.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click here
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (STEERING PAD SWITCH SIGNAL)
|
(a) Disconnect the I55 radio and display receiver assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I55-21 (SW1) - I55-24 (SWG)
|
No switch pushed
|
95 to 105 kΩ
|
Seek+ switch pushed
|
Below 2.5 Ω
|
Seek- switch pushed
|
313 to 345 Ω
|
Volume+ switch pushed
|
950 to 1050 Ω
|
Volume- switch pushed
|
2955 to 3265 Ω
|
I55-22 (SW2) - I55-24 (SWG)
|
No switch pushed
|
95 to 105 kΩ
|
MODE switch pushed
|
Below 2.5 Ω
|
On/off hook switch pushed
|
950 to 1050 Ω
|
Voice switch pushed
|
2955 to 3265 Ω
|
NG
|
|
|
2.
|
INSPECT STEERING PAD SWITCH ASSEMBLY
|
(a) Remove the steering pad switch assembly.
Click here
(b) Inspect the steering pad switch assembly.
Click here
OK
|
|
|
3.
|
INSPECT SPIRAL CABLE SUB-ASSEMBLY
|
(a) Remove the spiral cable sub-assembly.
Click here
(b) Inspect the spiral cable sub-assembly.
Click here
OK |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
|
|