Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001D09M |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 03/2019] |
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B1585; USB Device Malfunction; 2019 - 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 03/2019] |
DTC
|
B1585
|
USB Device Malfunction
|
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
DTC No.
|
Detection Item
|
DTC Detection Condition
|
Trouble Area
|
B1585
|
USB Device Malfunction
|
When any of the following conditions is met:
-
A non mass-storage class or incompatible protocol USB device connected
-
USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) connected
-
"iPod" malfunction
-
"iPod" with unsupported firmware connected
-
Unsupported "iPod" model connected
|
-
USB device or "iPod"
-
Radio and display receiver assembly
|
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio and display receiver assembly may not operate normally.
PROCEDURE
1.
|
REPLACE USB DEVICE OR "iPod"
|
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the engine switch off.
HINT:
When this DTC has been stored, it is necessary to turn the engine switch off to make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the engine switch on (ACC).
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
-
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
-
Refer to System Description for compatible formats and versions.
Click here
NEXT
|
|
|
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes
OK:
No DTCs are output.
OK |
|
END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE)
|
|