REPLACEMENT

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here

2. REMOVE REAR ENGINE UNDER COVER LH

Click here

3. DRAIN MANUAL TRANSAXLE OIL

(a) Remove the manual transmission filler plug and gasket from the manual transmission case.

(b) Loosen the manual transmission drain plug 6 to 7 turns and wait until the oil is completely drained out.

NOTICE:

When removing the manual transmission drain plug, do not loosen the manual transmission drain plug excessively, as loosening it more than 9 turns can cause the manual transmission drain plug to detach and manual transaxle oil to splash onto the crossmember or other parts.

In order to prevent manual transaxle oil from splashing onto the crossmember, the manual transmission drain plug has a mechanism that allows the oil to drain out gradually after 6 to 7 loosening cycles.

(c) Wait until the manual transaxle oil flow slows and only drops come out, and then remove the drain plug and gasket.

(d) Install a new gasket and the manual transmission drain plug to the manual transmission case.

Torque:

39.2 N·m {400 kgf·cm, 29 ft·lbf}

4. ADD MANUAL TRANSAXLE OIL

(a) Add manual transaxle oil until the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the manual transmission filler plug opening. Manual Transaxle Oil: "Toyota Genuine Manual Transmission Gear Oil LV" or "API GL-4 and SAE 75W" Standard Capacity: 1.5 liters (1.6 US qts, 1.3 Imp. qts)

*a 0 to 5 mm (0 to 0.197 in.)

(b) Install a new gasket and the manual transmission filler plug to the manual transmission case.

Torque:

39.2 N·m {400 kgf·cm, 29 ft·lbf}

5. INSPECT FOR MANUAL TRANSAXLE OIL LEAK

6. INSTALL REAR ENGINE UNDER COVER LH

Click here

7. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Click here