INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Pass the transmission control cable assembly into the vehicle and install it to the vehicle body with the 2 nuts.

Torque:

6.0 N·m {61 kgf·cm, 53 in·lbf}

(b) Engage the guide and connect the transmission control cable assembly to the vehicle body.

(c) Install the nut.

Torque:

6.0 N·m {61 kgf·cm, 53 in·lbf}

(d) Install the transmission control cable assembly to the control cable bracket assembly with 2 new clips (B). NOTICE: Make sure that the paint marks on the transmission control cable assembly are aligned with the slits in the control cable bracket assembly before installing the clips.

*a Paint Mark

(e) Connect the transmission control cable assembly to the manual transaxle assembly with the 2 clips (A).

(f) Turn the lock nut of the transmission control select cable counterclockwise. While holding the lock nut, push in the stopper.

*a Lock Nut *b Push in *c Stopper

(g) Connect the transmission control select cable to the floor shift lever assembly. NOTICE: After installation, check that the outer part of the stopper is as shown in the illustration. Do not forcibly pull the transmission control cable assembly into the cabin.

*a Stopper

(h) Connect the transmission control shift cable to the floor shift lever assembly in the same manner as the transmission control select cable.

(i) Connect the transmission control shift cable to the floor shift lever assembly.

(j) Connect the transmission control select cable to the floor shift lever assembly with the clip.

2. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

Click here

3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

(a) Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

Torque:

5.0 N·m {51 kgf·cm, 44 in·lbf}

4. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Click here

5. INSTALL FRONT FLOOR CENTER BRACE

Click here

6. INSTALL FRONT FLOOR COVER RH

Click here

7. INSTALL FRONT FLOOR COVER LH

Click here

8. INSTALL BATTERY CLAMP SUB-ASSEMBLY

Click here

9. INSTALL ECM

Click here

10. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Click here

11. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Click here

12. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Click here

13. INSTALL INLET NO. 1 AIR CLEANER

Click here

14. INSTALL RADIATOR SUPPORT OPENING COVER

Click here

15. INSTALL CONSOLE BOX ASSEMBLY

Click here

16. INSTALL BATTERY

Click here

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

18. INSPECT FOR EXHAUST GAS LEAK

Click here