THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, Gasoline Model): U0100,U0140,U0155; Lost Communication with ECM / PCM; 2019 - 2022 MY Corolla Corolla Hatchback GR Corolla [06/2018

DESCRIPTION

These DTCs are stored when there is a CAN communication malfunction between the certification ECU (smart key ECU assembly) and ECM, main body ECU (multiplex network body ECU) or combination meter assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

U0100

Lost Communication with ECM / PCM

CAN communication malfunction between certification ECU (smart key ECU assembly) and ECM (1-trip detection logic*)

ECM

DTC Output Confirmation Operation:

Turn the engine switch on (IG) and wait at least 10 seconds.

U0140

Lost Communication with Main Body ECU

CAN communication malfunction between certification ECU (smart key ECU assembly) and main body ECU (multiplex network body ECU) (1-trip detection logic*)

Main body ECU (multiplex network body ECU)

DTC Output Confirmation Operation:

Always

U0155

Lost Communication with Combination Meter

CAN communication malfunction between certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection logic*)

Combination meter assembly

DTC Output Confirmation Operation:

Turn the engine switch on (IG) and wait at least 10 seconds.

*: Only detected while a malfunction is present.

Vehicle Condition and Fail-safe Function when Malfunction Detected

DTC Code

Vehicle Condition when Malfunction Detected

Fail-safe Function when Malfunction Detected

U0100

There is no effect on vehicle behavior.

If the following conditions are met, it can be determined that the malfunction is not in the direct line (NE) but in the CAN communication system.

When the engine switch is pressed, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.
When the engine switch is pressed and held, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.

If the following conditions are met, it can be determined that there is a malfunction in both the CAN communication system and the direct line (NE).

When the engine switch is pressed, the engine stops cranking after 6 seconds.
When the engine switch is pressed and held, the engine remains cranking for up to 30 seconds.

U0140

Doors cannot be locked or unlocked.
The warning (wireless buzzer) does not sound.

U0155

The warning (meter buzzer) does not sound and no warning messages displayed on the multi-information display.

Related Data List and Active Test Items

DTC No.

Data List and Active Test

U0100

U0140

U0155

CAUTION / NOTICE / HINT

NOTICE:

When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus Body Electrical Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

PROCEDURE

CHECK FOR DTC

(a) Check for DTCs and note any DTCs that are output.

Click here

2019 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 01/2019]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, Gasoline Model): DTC CHECK / CLEAR

2020 - 2022 MY Corolla Corolla Hatchback GR Corolla [01/2019 - 09/2022]; THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function, Gasoline Model): DTC CHECK / CLEAR