| Last Modified: 07-31-2024 | 6.11:8.1.0 | Doc ID: RM100000001CXN7 |
| Model Year Start: 2019 | Model: GR Corolla | Prod Date Range: [06/2018 - ] |
| Title: LIGHTING (EXT): AUTOMATIC HIGH BEAM MAIN SWITCH: INSPECTION; 2019 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - ] | ||
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
|
*a |
Component without harness connected (Auto High Beam Switch) |
(a) Resistance Check
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
5 (+B) - 2 (E) |
Auto high beam switch off |
10 kΩ or higher |
|
Auto high beam switch on |
Below 1 Ω |
If the result is not as specified, replace the auto high beam switch.
(b) Illumination Inspection
(1) Apply battery voltage to the auto high beam switch and check that the switch illuminates.
OK:
Switch Illumination
|
Measurement Condition |
Condition |
Specified Condition |
|---|---|---|
|
Battery positive (+) → Terminal 6 (ILL+) Battery negative (-) → Terminal 1 (ILL-) |
Always |
Switch illumination illuminates |
OK:
Switch Indicator
|
Measurement Condition |
Condition |
Specified Condition |
|---|---|---|
|
Battery positive (+) → Terminal 3 (IND+) Battery negative (-) → Terminal 4 (AZBI) |
Always |
Switch indicator illuminates |
If the result is not as specified, replace the auto high beam switch.
|
|