NOTICE:

• If the battery is connected, the parking brake will operate when the electric parking brake switch assembly is pulled to the lock side even if the engine switch is off. Do not operate the electric parking brake switch assembly with the battery connected unless specified in the repair manual.
• To prevent the electric parking brake system from operating when the shift lever is moved, make sure that the shift-linked function is disabled. (for CVT)
• To prevent the electric parking brake system from operating when the engine switch is turned off, make sure that the AUTO function (IG-OFF linked function) is disabled. (for Manual Transaxle)
• The electric parking brake may still operate up to 20 seconds after the engine switch is turned off. Before disconnecting connectors or fuses, turn the engine switch off and wait 20 seconds or more.
• If any part is removed and installed, check for DTCs to make sure that the normal system code is output after all parts are installed.

  Click here

• Replacing a part with a part which does not meet the same specifications may affect the performance of the brake system or lead to a hazardous situation. When replacing a part, always use a part with the same part number or equivalent.
• When servicing the brake system, keep the parts and areas around the parts clean.
• If the vehicle is equipped with a mobile communication system, make sure to read the related precautions in Introduction.

  Click here

• When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force may not be sufficient. Make sure to pull the electric parking brake switch (electric parking brake switch assembly) to the lock side 2 times (2 lock operations).
  • The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag sensor assembly).
  • When the parking brake indicator (red) is illuminated after the electric parking brake switch (electric parking brake switch assembly) has been pulled to the lock side, the maximum amount of braking force is applied if the electric parking brake switch (electric parking brake switch assembly) is pulled to the lock side one more time.