|
Last Modified: 01-27-2025 |
6.11:8.1.0 |
Doc ID: RM100000001CW2T |
|
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 01/2019] |
|
Title: BRAKE (REAR): REAR BRAKE (w/ Electric Parking Brake): REMOVAL; 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019] |
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
-
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
-
After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. PERFORM REAR BRAKE PAD REPLACEMENT MODE
Click here
3. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.
4. SEPARATE REAR FLEXIBLE HOSE
|
(a) Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
|
|
5. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here
6. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY
Click here
7. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
|
(a) Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and rear disc brake cylinder assembly.
|
|
8. REMOVE REAR DISC BRAKE PAD
|
(a) Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.
|
|
9. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
Click here
10. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
|
(a) Remove the 4 rear disc brake pad support plates from the rear disc brake cylinder mounting.
NOTICE:
Each rear disc brake pad support plate has a different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that it can be reinstalled to its original position.
|
|
11. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
|
(a) Remove the rear No. 1 disc brake cylinder slide pin and rear No. 2 disc brake cylinder slide pin from the rear disc brake cylinder mounting.
|
|
|
*1
|
Rear No. 1 Disc Brake Cylinder Slide Pin
|
|
*2
|
Rear No. 2 Disc Brake Cylinder Slide Pin
|
|
|
|
(b) Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake cylinder slide bushing from the rear No. 2 disc brake cylinder slide pin.
NOTICE:
Do not damage the rear No. 2 disc brake cylinder slide pin.
|
|
12. REMOVE REAR DISC BRAKE BUSHING DUST BOOT
|
(a) Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.
|
|
13. REMOVE REAR DISC BRAKE CYLINDER MOUNTING
|
(a) Remove the 2 bolts and rear disc brake cylinder mounting.
|
|
14. REMOVE REAR DISC
|
(a) Put matchmarks on the rear disc and rear axle hub and bearing assembly.
|
|
(b) Remove the rear disc.
|