Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001CW2T |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 01/2019] |
Title: BRAKE (REAR): REAR BRAKE (w/ Electric Parking Brake): REMOVAL; 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019] |
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
-
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
-
After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. PERFORM REAR BRAKE PAD REPLACEMENT MODE
Click here
3. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.
4. SEPARATE REAR FLEXIBLE HOSE
(a) Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
|
|
5. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here
6. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY
Click here
7. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY
(a) Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and rear disc brake cylinder assembly.
|
|
8. REMOVE REAR DISC BRAKE PAD
(a) Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.
|
|
9. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
Click here
10. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
(a) Remove the 4 rear disc brake pad support plates from the rear disc brake cylinder mounting.
NOTICE:
Each rear disc brake pad support plate has a different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that it can be reinstalled to its original position.
|
|
11. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
(a) Remove the rear No. 1 disc brake cylinder slide pin and rear No. 2 disc brake cylinder slide pin from the rear disc brake cylinder mounting.
|
|
*1
|
Rear No. 1 Disc Brake Cylinder Slide Pin
|
*2
|
Rear No. 2 Disc Brake Cylinder Slide Pin
|
|
|
(b) Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake cylinder slide bushing from the rear No. 2 disc brake cylinder slide pin.
NOTICE:
Do not damage the rear No. 2 disc brake cylinder slide pin.
|
|
12. REMOVE REAR DISC BRAKE BUSHING DUST BOOT
(a) Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.
|
|
13. REMOVE REAR DISC BRAKE CYLINDER MOUNTING
(a) Remove the 2 bolts and rear disc brake cylinder mounting.
|
|
14. REMOVE REAR DISC
(a) Put matchmarks on the rear disc and rear axle hub and bearing assembly.
|
|
(b) Remove the rear disc.
|