Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001CVPA |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 01/2019] |
Title: HEATING / AIR CONDITIONING: FRONT EVAPORATOR TEMPERATURE SENSOR: REMOVAL; 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019] |
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane Control System
|
|
Pre-collision System
|
Lighting System (w/ AFS)(EXT)
|
Initialize back door lock
|
Power Door Lock Control System
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
NOTICE:
-
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)
-
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)
PROCEDURE
1. REMOVE BLOWER ASSEMBLY
Click here
2. REMOVE AIR CONDITIONING HARNESS ASSEMBLY
Click here
3. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Click here
4. REMOVE HEATER GROMMET
Click here
5. REMOVE HEATER CLAMP
Click here
6. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Click here
7. REMOVE COOLING UNIT PARTS
Click here
8. REMOVE COOLER EXPANSION VALVE
Click here
9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Click here
10. REMOVE NO. 1 COOLER THERMISTOR
(a) Remove the No. 1 cooler thermistor.
|
|
|