Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001CU0F |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 01/2019] |
Title: EXTERIOR PANELS / TRIM: REAR DOOR BELT MOULDING: INSTALLATION; 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019] |
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2. INSTALL REAR DOOR BELT MOULDING
(a) Engage the 7 claws as shown in the illustration to install a new rear door belt moulding.
|
Install in this Direction
|
3. INSTALL REAR DOOR QUARTER WINDOW WEATHERSTRIP WITH REAR DOOR QUARTER WINDOW GLASS
Click here
4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Click here
5. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Click here
6. CONNECT REAR DOOR WEATHERSTRIP
Click here
7. INSTALL REAR DOOR GLASS RUN
Click here
8. INSTALL REAR DOOR SERVICE HOLE COVER
Click here
9. INSTALL REAR DOOR PANEL PROTECTOR
Click here
10. INSTALL REAR DOOR NO. 1 VENT SEAL
Click here
11. INSTALL REAR DOOR FRAME GARNISH
Click here
12. INSTALL REAR SPEAKER ASSEMBLY
Click here
13. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
17. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here
18. INSPECT POWER WINDOW OPERATION
Click here
|