Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001CU06 |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 -
] |
Title: EXTERIOR PANELS / TRIM: REAR BUMPER (for Hatchback except GR): REMOVAL; 2019 - 2025 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - ] |
REMOVAL
CAUTION / NOTICE / HINT
HINT:
If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Click here
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER LH
Click here
2. REMOVE REAR COMBINATION LIGHT COVER RH
HINT:
Use the same procedure as for the LH side.
3. REMOVE REAR BUMPER ASSEMBLY
(a) Apply protective tape around the rear bumper assembly as shown in the illustration.
|
Protective Tape
|
(c) Remove the clip.
HINT:
Use the same procedure for the RH side and LH side.
|
|
(d) w/o Rear Under Cover:
(1) Remove the 6 clips.
|
|
(e) w/ Rear Under Cover:
(1) Remove the 10 clips.
|
|
(f) Disengage the 8 claws as shown in the illustration.
|
Place Hand Here
|
|
Remove in this Direction
|
HINT:
Use the same procedure for the RH side and LH side.
(g) Disengage the 4 claws as shown in the illustration.
|
Remove in this Direction
|
(h) Disconnect the connector to remove the rear bumper assembly.
|