Last Modified: 05-13-2024 |
6.11:8.1.0 |
Doc ID: RM100000001C4DT |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 -
] |
Title: POWER OUTLETS (INT): WIRELESS CHARGING SYSTEM (for Gasoline Model): Wireless Charger Illumination Circuit; 2019 - 2025 MY Corolla Corolla Hatchback GR Corolla [06/2018 - ] |
Wireless Charger Illumination Circuit
|
DESCRIPTION
When the taillight on, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
|
(a) Disconnect the I73 mobile wireless charger cradle assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
I73-10 (TAIL) - Body ground
|
Taillight off
|
Below 1 V
|
Engine switch off, taillight on
|
11 to 14 V
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
OK
|
|
|
2.
|
CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - MOBILE WIRELESS CHARGER CRADLE ASSEMBLY)
|
(a) Disconnect the I4 combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
I4-35 (ILL-) - I73-9 (ILL-)
|
Always
|
Below 1 Ω
|
I4-35 (ILL-) or I73-9 (ILL-) - Body ground
|
Always
|
10 kΩ or higher
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|