Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM100000001C0X9
Model Year Start: 2019 Model: GR Corolla Prod Date Range: [06/2018 - 09/2019]
Title: POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for Gasoline Model (for Hatchback)): C1552,C1554; PIG Power Supply Voltage; 2019 - 2020 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2019]

DTC

C1552

PIG Power Supply Voltage

DTC

C1554

Power Supply Relay Failure

DESCRIPTION

If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Return-to-normal Condition

Note

C1552

PIG Power Supply Voltage

PIG power source circuit malfunction
  • EPS fuse
  • PIG power source circuit
  • Power steering ECU with motor assembly

EPS warning light: Comes on

Engine switch on (IG) again

-

C1554

Power Supply Relay Failure

Power source relay circuit malfunction
  • EPS fuse
  • PIG power source circuit
  • Power steering ECU with motor assembly

EPS warning light: Comes on

Engine switch on (IG) again

-

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • If the power steering ECU with motor assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

    Click here 2019 - 2020 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2019]; POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for Gasoline Model (for Hatchback)): CALIBRATION

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (POWER STEERING ECU WITH MOTOR ASSEMBLY - BODY GROUND)

(a) Disconnect the I42 power steering ECU with motor assembly connectors.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

I42-1 (PIG) - Body ground

Always

9 to 16 V

*a

Front view of wire harness connector

(to Power Steering ECU with Motor Assembly)

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

I42-2 (PGND) - Body ground

Always

Below 1 Ω
OK

REPLACE POWER STEERING ECU WITH MOTOR ASSEMBLY 2019 MY Corolla Corolla Hatchback Corolla HV GR Corolla [06/2018 - 01/2019]; POWER ASSIST SYSTEMS: POWER STEERING ECU: REMOVAL 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [01/2019 - 03/2019]; POWER ASSIST SYSTEMS: POWER STEERING ECU: REMOVAL 2020 MY Corolla Corolla Hatchback Corolla HV GR Corolla [03/2019 - 09/2019]; POWER ASSIST SYSTEMS: POWER STEERING ECU: REMOVAL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR