| Last Modified: 05-13-2024 | 6.11:8.1.0 | Doc ID: RM100000001C0X1 |
| Model Year Start: 2019 | Model: GR Corolla | Prod Date Range: [06/2018 - 09/2019] |
| Title: POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for Gasoline Model (for Hatchback)): C1513; Torque Sensor Deviation Excessive; 2019 - 2020 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2019] | ||
|
DTC |
C1513 |
Torque Sensor Deviation Excessive |
DESCRIPTION
The power steering ECU with motor assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque.
The Hall IC is a duplex system, and the power steering ECU with motor assembly monitors the total value of TRQ1 (Hall IC 1) voltage and TRQ2 (Hall IC 2) voltage to detect malfunctions in the torque sensor (electric power steering column sub-assembly).
While DTC C1513 is detected, power assist is stopped due to fail-safe operation.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Warning Indicate |
Return-to-normal Condition |
Note |
|---|---|---|---|---|---|---|
|
C1513 |
Torque Sensor Deviation Excessive |
Deviation of torque sensor TRQ1 and TRQ2 exceeds specified values |
Torque sensor (Electric power steering column sub-assembly) |
EPS warning light: Comes on |
Engine switch on (IG) again |
- |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the electric power steering column sub-assembly has been replaced, perform torque sensor zero point calibration.
Click here
![2019 - 2020 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2019]; POWER ASSIST SYSTEMS: POWER STEERING SYSTEM (for Gasoline Model (for Hatchback)): CALIBRATION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Check for DTCs.
Click here
Chassis > EMPS > Trouble Codes
OK:
DTC C1511 and C1512 are not output.
|
Result |
Proceed to |
|---|---|
|
DTCs C1511 and C1512 are not output |
A |
|
DTC C1511 is output |
B |
|
DTC C1512 is output |
C |
| B |
|
| C |
|
|
|
2. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
Chassis > EMPS > Clear DTCs
|
|
3. |
RECONFIRM DTC |
(a) Start the engine.
(b) With the vehicle stopped, turn the steering wheel all the way to the left and right.
HINT:
Turn the wheel both strongly and gently when steering back and forth.
(c) Check for DTCs.
Click here
Chassis > EMPS > Trouble Codes
OK:
DTC C1513 is not output.
| OK |
|
| NG |
|
REPLACE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY
|
|
|