Last Modified: 07-31-2024 6.11:8.1.0 Doc ID: RM100000001BH0C
Model Year Start: 2019 Model: Corolla Hatchback Prod Date Range: [06/2018 -           ]
Title: M20A-FKS (ENGINE CONTROL): MASS AIR FLOW METER: REMOVAL; 2019 - 2025 MY Corolla Corolla Hatchback [06/2018 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Replacement of mass air flow meter sub-assembly

Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.

2019 - 2020 MY Corolla Corolla Hatchback [06/2018 - 09/2019]; M20A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION 2020 MY Corolla Corolla Hatchback [09/2019 - 04/2020]; M20A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION 2021 - 2023 MY Corolla Corolla Hatchback [04/2020 - 11/2022]; M20A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION 2023 - 2025 MY Corolla Corolla Hatchback [11/2022 -        ]; M20A-FKS (ENGINE CONTROL): SFI SYSTEM: INITIALIZATION

PROCEDURE

1. REMOVE MASS AIR FLOW METER SUB-ASSEMBLY

(a) Disconnect the mass air flow meter sub-assembly connector.

(b) Remove the 2 screws and mass air flow meter sub-assembly from the air cleaner cap sub-assembly.

NOTICE:

If the mass air flow meter sub-assembly has been struck or dropped, replace it.