Last Modified: 07-31-2024 |
6.11:8.1.0 |
Doc ID: RM100000001B0N9 |
Model Year Start: 2019 |
Model: GR Corolla |
Prod Date Range: [06/2018 - 09/2022] |
Title: WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM (for Gasoline Model): Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated); 2019 - 2022 MY Corolla Corolla Hatchback GR Corolla [06/2018 - 09/2022] |
Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)
|
DESCRIPTION
If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the power window.
CAUTION / NOTICE / HINT
NOTICE:
-
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click here
-
If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.
Click here
HINT:
This symptom may occur for any of the power windows.
PROCEDURE
1.
|
PERFORM INITIALIZATION (APPLICABLE LOCATION)
|
(a) Initialize the power window regulator motor assembly (applicable location).
Click here
NEXT
|
|
|
2.
|
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION (APPLICABLE LOCATION))
|
(a) Check that each power window moves when the auto up and down functions of the multiplex network master switch assembly or power window regulator switch assembly or rear power window regulator switch assembly is operated.
Click here
OK:
Auto up and down functions are normal (applicable location).
OK |
|
END (PROBLEM DUE TO INITIALIZATION FAILURE)
|
NG
|
|
|
3.
|
CHECK DOOR GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
|
(a) Remove the power window regulator motor assembly and door window regulator sub-assembly.
(b) Install the door glass to the door glass run.
(c) Check that the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
(d) Check that the door glass slides smoothly when sliding it down by hand.
NOTICE:
Make sure to perform initialization again.
HINT:
Ensure the following:
-
The door glass fits in the door glass run without improper contact or deformation.
-
Foreign matter is not caught in the door glass run.
-
The door glass run is not misaligned.
-
The door glass is not tilted and does not catch on the door glass run.
OK:
Door glass slides smoothly.
Result
|
Proceed to
|
OK (Driver door power window)
|
A
|
OK (Front passenger door power window)
|
OK (Rear LH door power window)
|
B
|
OK (Rear RH door power window)
|
NG
|
C
|
C |
|
FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)
|
|