- Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.*1
- Drive the vehicle straight ahead at 15 km/h (9 mph) or more for 1 second or more.*2
| Last Modified: 08-22-2025 | 6.11:8.1.0 | Doc ID: RM0000003TPDC2N |
| Model Year Start: 2026 | Model: GR Corolla | Prod Date Range: [08/2025 - ] |
| Title: SEAT BELT: OCCUPANT DETECTION SENSOR: REMOVAL; 2026 MY Corolla Corolla Hatchback Corolla HV GR Corolla [08/2025 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during occupant detection sensor (separate type front seat cushion pad) removal/installation are shown below.
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
![2023 - 2026 MY Corolla Corolla Hatchback Corolla HV GR Corolla [11/2022 - ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
NOTICE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
|
Effect/Inoperative Function When Necessary Procedures are not Performed |
Necessary Procedures |
Link |
|---|---|---|
|
*1: for GR Model
*2: except GR Model |
||
|
Front Camera System |
|
|
Learning completes when vehicle is operated normally
|
Effect/Inoperative Function When Necessary Procedures are not Performed |
Necessary Procedures |
Link |
|---|---|---|
| *1: for Hatchback | ||
|
Power Door Lock Control System
|
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. |
|
- It is necessary to perform the same operation after removing and installing the system supply power fuse.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
HINT:
Use the same procedure as for the driver seat.
Click here
2. REMOVE FRONT SEAT INNER BELT ASSEMBLY
Click here
3. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
HINT:
Use the same procedure as for the driver seat.
Click here
4. REMOVE RECLINING HINGE COVER
HINT:
Use the same procedure as for the driver seat.
Click here
5. REMOVE RECLINING ADJUSTER RELEASE HANDLE
HINT:
Use the same procedure as for the driver seat.
Click here
6. REMOVE FRONT SEAT CUSHION SHIELD
Click here
7. REMOVE FRONT SEAT INNER CUSHION SHIELD
Click here
8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
HINT:
Use the same procedure as for the driver seat.
Click here
9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
HINT:
Use the same procedure as for the driver seat.
Click here
10. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
(a) Using a screwdriver, disengage the 13 claws and remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.
|
*a |
Screwdriver |
- |
- |
|
|