Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000002EKGQ
Model Year Start: 2024 Model: RAV4 Prod Date Range: [10/2023 -           ]
Title: DOOR LOCK: REAR DOOR LOCK: REMOVAL; 2024 MY RAV4 RAV4 HV [10/2023 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedures

Necessary Procedures

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

*: When performing learning using the Techstream.

Click here 2024 MY RAV4 HV [10/2023 -        ]; PARK ASSIST / MONITORING: PARKING SUPPORT BRAKE SYSTEM (for HV Model): CALIBRATION

Removal and installation of auxiliary battery terminal

Perform steering sensor zero point calibration

Lane control system

2022 - 2024 MY RAV4 RAV4 HV [12/2021 -        ]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Parking support brake system (for HV model)*

Pre-collision system

Reset back door close position

Power back door system

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: INITIALIZATION

Back door lock initialization

Power door lock control system

2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: INITIALIZATION

  • Power window regulator motor assembly LH
  • Power window regulator motor assembly RH
  • Rear door window regulator sub-assembly LH
  • Rear door window regulator sub-assembly RH
  • Rear door glass sub-assembly LH
  • Rear door glass sub-assembly RH
  • Rear door glass run LH
  • Rear door glass run RH

Initialize power window control system

  • Auto up and down function
  • Jam protection function
  • Catch protection function
  • Remote control function
  • Wireless transmitter-linked function
  • Key-linked function
  • Key-off operation function
  • Window open warning function

2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: INITIALIZATION

NOTICE:

  • After the ignition switch is turned off, the audio and visual system records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 2 minutes before disconnecting the cable from the negative (-) auxiliary battery terminal.
  • When the cable is disconnected from the negative (-) auxiliary battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) auxiliary battery terminal.

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedures

Necessary Procedures

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

*1: When performing learning using the Techstream.

Click here 2024 MY RAV4 [10/2023 -        ]; PARK ASSIST / MONITORING: PARKING SUPPORT BRAKE SYSTEM (for Gasoline Model): CALIBRATION

*2: w/o Power Back Door System

Removal and installation of auxiliary battery terminal

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)

Stop and start system

2024 MY RAV4 [10/2023 -        ]; STOP AND START: STOP AND START SYSTEM: PRECAUTION

Perform steering sensor zero point calibration

Lane control system

2022 - 2024 MY RAV4 RAV4 HV [12/2021 -        ]; PRE-COLLISION: PRE-COLLISION SYSTEM: INITIALIZATION

Parking support brake system (for Gasoline model)*1

Pre-collision system

Reset back door close position

Power back door system

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: INITIALIZATION

Back door lock initialization*2

Power door lock control system

2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: INITIALIZATION

  • Power window regulator motor assembly LH
  • Power window regulator motor assembly RH
  • Rear door window regulator sub-assembly LH
  • Rear door window regulator sub-assembly RH
  • Rear door glass sub-assembly LH
  • Rear door glass sub-assembly RH
  • Rear door glass run LH
  • Rear door glass run RH

Initialize power window control system

  • Auto up and down function
  • Jam protection function
  • Catch protection function
  • Remote control function
  • Wireless transmitter-linked function
  • Key-linked function
  • Key-off operation function
  • Window open warning function

2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: INITIALIZATION

NOTICE:

  • After the ignition switch is turned off, the audio and visual system records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 2 minutes before disconnecting the cable from the negative (-) auxiliary battery terminal.
  • When the cable is disconnected from the negative (-) auxiliary battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) auxiliary battery terminal.

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure below is for the LH side.
  • When performing disassembly for the rear door, disconnect the negative (-) auxiliary battery terminal after fully opening the rear door glass.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here 2019 - 2024 MY RAV4 RAV4 HV [11/2018 -        ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION

2. REMOVE DECK BOARD ASSEMBLY (for HV Model)

Click here 2024 MY RAV4 HV [10/2023 -        ]; MAINTENANCE: A25A-FXS AUXILIARY BATTERY: REMOVAL+

3. REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)

Click here 2024 MY RAV4 HV [10/2023 -        ]; MAINTENANCE: A25A-FXS AUXILIARY BATTERY: REMOVAL+

4. REMOVE BATTERY HOLE COVER (for HV Model)

Click here 2024 MY RAV4 HV [10/2023 -        ]; MAINTENANCE: A25A-FXS AUXILIARY BATTERY: REMOVAL+

5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

(a) for A25A-FXS:

Click here 2024 MY RAV4 HV [10/2023 -        ]; MAINTENANCE: A25A-FXS AUXILIARY BATTERY: REMOVAL+

(b) for A25A-FKS:

Click here 2024 MY RAV4 [10/2023 -        ]; MAINTENANCE: A25A-FKS BATTERY: REMOVAL+

CAUTION:

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
  • If the airbag deploys for any reason, it may cause a serious accident.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION

6. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

7. REMOVE DOOR ASSIST GRIP COVER LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

8. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

11. REMOVE REAR DOOR FRONT BELT SEAL LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

12. REMOVE REAR DOOR REAR BELT SEAL LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

13. REMOVE REAR DOOR SERVICE HOLE COVER LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

14. REMOVE REAR DOOR FRAME GARNISH LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

15. DISCONNECT REAR DOOR GLASS RUN LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

16. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

17. REMOVE REAR DOOR GLASS RUN LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

18. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

19. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: REAR DOOR: DISASSEMBLY+

20. REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY LH

(a) Using a T30 "TORX" socket wrench, remove the 3 "TORX" screws.

*a

Release Plate

Remove in this Direction

(b) Remove the release plate of the rear door outside handle frame sub-assembly LH in the direction indicated by the arrow shown in the illustration to remove the rear door lock with motor assembly LH.

21. REMOVE DOOR LOCK WIRING HARNESS SEAL

(a) When reusing rear door lock with motor assembly LH:

(1) Remove the door lock wiring harness seal from the rear door lock with motor assembly LH.

22. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, detach the claw and open the cover.

Remove in this Direction

Protective Tape

(b) Detach the clamp and remove the rear door lock remote control cable assembly as shown in the illustration.

Remove in this Direction

23. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, detach the claw and open the cover.

Remove in this Direction

Protective Tape

(b) Detach the clamp and remove the rear door inside locking cable assembly as shown in the illustration.

Remove in this Direction