- Occupant classification system
- Passenger airbag ON/OFF indicator
- Airbag system (Front passenger side)
- Seat belt warning system (Front passenger)
| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM100000002EKG6 |
| Model Year Start: 2024 | Model: RAV4 | Prod Date Range: [10/2023 - ] |
| Title: SEAT: FRONT SEAT CUSHION HEATER (for Manual Seat): REMOVAL; 2024 MY RAV4 RAV4 HV [10/2023 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat cushion heater assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here
|
|||
|
Disconnect cable from negative (-) auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane control system |
|
|
Parking support brake system (for HV model)* |
|||
|
Pre-collision system |
|||
|
Reset back door close position |
Power back door system |
|
|
|
Back door lock initialization |
Power door lock control system |
|
|
|
Front passenger seat |
Zero point calibration (Occupant classification system) |
|
|
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here
*2: w/o Power Back Door System |
|||
|
Disconnect cable from negative (-) auxiliary battery terminal |
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) |
Stop and start system |
|
|
Perform steering sensor zero point calibration |
Lane control system |
|
|
|
Parking support brake system (for Gasoline model)*1 |
|||
|
Pre-collision system |
|||
|
Reset back door close position |
Power back door system |
|
|
|
Back door lock initialization*2 |
Power door lock control system |
|
|
|
Front passenger seat |
Zero point calibration (Occupant classification system) |
|
|
HINT:
- Use the same procedure for the RH and LH sides.
- The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
![2021 - 2024 MY RAV4 RAV4 HV [08/2020 - ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click here
2. REMOVE FRONT SEAT ASSEMBLY LH
Click here
3. REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)
Click here
4. REMOVE RECLINING HINGE COVER LH
Click here
5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Click here
6. REMOVE SEAT ADJUSTER COVER CAP LH (for Driver Side)
Click here
7. REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)
Click here
8. REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
Click here
9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
Click here
10. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
Click here
11. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Click here
12. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Click here
13. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Click here
14. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
|
(a) Remove the 16 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover. NOTICE: Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH. |
|
15. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH
(a) for Standard Seat Type:
|
(1) w/o Climate Control Seat System: Remove the 16 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover. NOTICE: Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH. |
|
|
(2) w/ Climate Control Seat System: Remove the 19 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover. NOTICE: Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH. |
|
(b) for Sports Seat Type:
|
(1) w/o Climate Control Seat System: Remove the 16 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover. NOTICE: Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH. |
|
|
(2) w/ Climate Control Seat System: Remove the 19 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover. NOTICE: Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH. |
|
|
|