Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM100000002EKCE
Model Year Start: 2024 Model: RAV4 Prod Date Range: [10/2023 -           ]
Title: DOOR / HATCH: POWER BACK DOOR DRIVE UNIT: REMOVAL; 2024 MY RAV4 RAV4 HV [10/2023 -        ]

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power back door unit assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

  • Power back door unit assembly LH
  • Power back door unit assembly RH

Reset connection history

There are cases where the connection history display differs from the vehicle condition

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: DATA LIST / ACTIVE TEST

Reset back door close position

Power back door system

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: INITIALIZATION

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

  • Power back door unit assembly LH
  • Power back door unit assembly RH

Reset connection history

There are cases where the connection history display differs from the vehicle condition

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: DATA LIST / ACTIVE TEST

Reset back door close position

Power back door system

2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: POWER BACK DOOR SYSTEM: INITIALIZATION

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure below is for the LH side.

PROCEDURE

1. REMOVE BACK DOOR CENTER GARNISH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: BACK DOOR: DISASSEMBLY+

2. REMOVE BACK DOOR SIDE GARNISH LH

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: BACK DOOR: DISASSEMBLY+

3. REMOVE BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.

4. REMOVE BACK DOOR GRIP BASE

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: BACK DOOR: DISASSEMBLY+

5. REMOVE BACK DOOR GRIP

HINT:

Use the same procedure described for the back door grip base.

6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Click here 2024 MY RAV4 RAV4 HV [10/2023 -        ]; DOOR / HATCH: BACK DOOR: DISASSEMBLY+

7. REMOVE POWER BACK DOOR UNIT ASSEMBLY LH

CAUTION:

  • Do not perform work if the back door is not securely supported.
  • The back door could fall, resulting in injury.

(a) Disconnect the connector.

Grommet

Connector

Remove in this Direction

(b) Disconnect the grommet and pull out the power back door unit assembly LH harness as shown in the illustration.

(c) Using a screwdriver with its tip wrapped with protective tape, slightly raise the 2 stop rings as shown in the illustration.

Protective Tape

(d) Detach the 2 ball joints to remove the power back door unit assembly LH.

NOTICE:

  • Remove the power back door unit assembly LH while supporting the back door by hand.
  • Remove the back door stay assembly while supporting the back door stay assembly by hand.

8. REMOVE BACK DOOR UPPER DAMPER STAY BRACKET LH

(a) Remove the 2 bolts and back door upper damper stay bracket LH.

9. REMOVE BACK DOOR LOWER DAMPER STAY BRACKET LH

(a) Remove the 2 bolts and back door lower damper stay bracket LH with back door stay stopper.

10. REMOVE BACK DOOR STAY STOPPER

(a) Detach the claw and remove the back door stay stopper from the back door lower damper stay bracket LH.