- Poor idle, etc.
- Engine start function, etc.
| Last Modified: 01-30-2024 | 6.11:8.1.0 | Doc ID: RM1000000026THY |
| Model Year Start: 2023 | Model: RAV4 | Prod Date Range: [10/2022 - ] |
| Title: A25A-FKS (ENGINE CONTROL): KNOCK SENSOR: REMOVAL; 2023 - 2024 MY RAV4 [10/2022 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
|
Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
|
Knock control sensor |
Inspection after repair |
|
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
![2019 - 2024 MY RAV4 RAV4 HV [11/2018 - ]; INTRODUCTION: REPAIR INSTRUCTION: PRECAUTION](/t3Portal/stylegraphics/info.gif)
PROCEDURE
1. REMOVE GENERATOR ASSEMBLY
-
for 100 A, 130 A Type:
Click here
-
for 150 A Type:
Click here
2. REMOVE KNOCK CONTROL SENSOR
|
(a) Disconnect the knock control sensor connector. |
|
(b) Remove the bolt and knock control sensor from the cylinder block sub-assembly.
NOTICE:
If the knock control sensor has been struck or dropped, replace it.
|
|