Last Modified: 01-30-2024 6.11:8.1.0 Doc ID: RM1000000026SV3
Model Year Start: 2023 Model: RAV4 HV Prod Date Range: [10/2022 -           ]
Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): C162011; Rear Camera Circuit Short to Ground; 2023 - 2024 MY RAV4 HV [10/2022 -        ]

DTC

C162011

Rear Camera Circuit Short to Ground

DESCRIPTION

This DTC is stored if the parking assist ECU determines that the input/output signal communication with the rear television camera assembly is abnormal.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

DTC Output from

Priority

C162011

Rear Camera Circuit Short to Ground

Rear television camera assembly power supply malfunction

  • Harness or connector
  • Rear television camera assembly
  • Parking assist ECU

Circumference Monitoring Camera Control Module

A

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click here 2023 - 2024 MY RAV4 HV [10/2022 -        ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM (for HV Model): CALIBRATION

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY)

Pre-procedure1

(a) Disconnect the N80 parking assist ECU connector.

(b) Disconnect the R31 rear television camera assembly connector.

Procedure1

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

N80-1 (CB+) - R31-2 (CB+)

Always

Below 1 Ω

N80-2 (CGND) - R31-1 (CGND)

Always

Below 1 Ω

N80-1 (CB+) or R31-2 (CB+) - Body ground

Always

10 kΩ or higher

N80-2 (CGND) or R31-1 (CGND) - Body ground

Always

10 kΩ or higher

Post-procedure1

(d) None

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK PARKING ASSIST ECU (CB+, CGND)

Pre-procedure1

(a) Disconnect the R31 rear television camera assembly.

Procedure1

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

R31-1 (CGND) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

R31-2 (CB+) - R31-1 (CGND)

Ignition switch ON

7.5 to 8.5 V

R31-2 (CB+) - R31-1 (CGND)

Ignition switch off

Below 1 V

Post-procedure1

(d) None

OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE PARKING ASSIST ECU